Land a Boeing 747

Many individuals fret over how to land the Boeing 747 in FSX. Many articles only tell you how to get on the runway. The truth is that the easiest way to land the 747 is to be prepared before you even take off. Good luck!

Steps

1. Create an IFR flight plan. You can do this before starting the simulation or while in the air. This is just in case you enter IMC and the airport at which you wish to land is under IFR only.
2. After establishing an IFR flight plan, proceed via GPS or VOR routing to you destination. Once ATC informs you of your approach clearance, begin landing procedures.
3. Decrease speed to about 200 KIAS using the autothrottle. This will allow for some time to go through the landing checklist.
4. If you haven't done so already, dial the ILS frequency into Nav 1 and set the omnibearing selector to the runway heading if you are under IFR to an airport with ILS. Otherwise, Determine the best approach using you GPS to line you up with the runway if possible or determine the best approach yourself under VFR and skip through irrelevant steps.
5. Once you have determined you approach, decrease your speed to 160 KIAS and apply flaps to full according to the maximum flap placard speeds. once flaps are at 10, lower the landing gear(V speeds can be found in the reference section of the kneeboard)
6. Once the readings on all of the instruments have stabilized, set the auto-brake to 3 and arm the speedbrake(shift+F10).
7. you have now completed all of the steps necessary in the approach for now. You should contact the tower now if you haven't already to inform them that you are inbound on the approach if possible.
8. Once you have informed the tower, check your instruments to see when the plane picks up the ILS.(you may need to turn off the GPS to check). at this point, switch from GPS to NAV and select the NAV hold button if not already on.
9. The next step is to wait until the vertical guidance indicator begins to move. once this happens, switch from NAV hold to APR hold.
10. When beginning the descent, check to make sure that autobrake is set to 3, flaps are at 30, and the speed-brake is armed.
11. When you are about {{safesubst:#invoke:convert|convert}} above the runway, turn off the autothrottle.
12. When you are beginning to level out, prepare to turn off the autopilot once the nose seems to abruptly drop.
13. after confirming you are on the ground, set the throttle to full reverse. When decelerating through 70 KIAS terminate the reverse thrust, set throttle levers to idle. (Reverse thrust below 60KIAS will damage the engines)
14. after reaching 15 KIAS, turn off the autobrake, and taxi off of the runway.
15. You have now safely landed.

Related Articles

• Land an Airplane in an Emergency
• Land a Commercial Transport Airplane
• Make a 3 Point Landing in a Tailwheel Airplane
• Calculate Aircraft Payload

See also

• Build a Grass Landing Strip
• Land a Helicopter After Your Pilot Has Been Killed
• Land a Cessna 172
• Calculate Aircraft Descent Rate