Paint a Pool
Paint is one of the most common pool surfaces. It comes in a variety of colors and is an inexpensive alternative to the more elaborate surface options. When attempting to paint a pool, one must first select the proper paint, prepare the pool properly, and follow all manufacturer's application guidelines. With the right materials, and some time and effort, you can have a brand new swimming pool without breaking the bank.
Contents
[hide]Steps
- Purchase the same type of paint previously used on your pool surface: epoxy, chlorinated rubber or acrylic.
- Remove a chip and have it tested by your local paint dealer to determine the type of paint that was used.
- Drain all of the water from the pool and remove any leaves, dirt or debris.
- Caulk or patch any existing cracks and holes with hydraulic cement. Follow the cement manufacturer's instructions.
- Clean the concrete surface.
- Remove any old paint by using a power washer or a scraper and wire brush. Ensure that all loose paint has been removed, then sweep the area clean.
- Use an acid wash mixture of 50% water and 50% muriatic acid to clean the pool surface. Thoroughly scrub the walls and floor with a scrub brush, then rinse the entire surface with clean water.
- Clean the surface again with tri-sodium phosphate (TSP) to neutralize the acid and remove dense areas of oil or grease. Rinse it completely with fresh water.
- Re-rinse the entire pool, including drains, lights, stairs, etc. Pump out any standing water and allow 3-to-5 days for the pool surface to dry. Only acrylic paint can be applied to damp surfaces.
- Apply the paint with an extension roller. Start in the deep end and work your way into the low end of the pool. Use a brush to cut in on the tight areas around pool fixtures such as lights, drains and valves.
- Allow the paint to dry per the manufacturer's instructions, particularly when using an epoxy paint as timing is crucial to proper adhesion. Typically, you must wait 3-to-5 days for the paint to dry before refilling the pool with water.
- Refill the newly painted pool with water and adjust the filter and chemical settings to ensure proper maintenance.
Tips
- Do not apply paint in extreme heat or cold or in extreme humidity. Extreme weather conditions may result in poor adhesion.
- Mix the pool paint well before using.
- Ensure that the paint is thinly applied to a properly prepared surface to prevent blistering.
Warnings
- Take the necessary safety precautions when using the acid wash solution, as it may be harmful to your eyes, lungs and skin.
Things You'll Need
- Muriatic acid
- Epoxy/acrylic/chlorinated rubber paint
- Paint roller pans
- Paint rollers with extension pole
- Paintbrushes
- Rubber gloves
- Power washer
- Safety goggles
- Scraper
- Scrub brush
- Tri-sodium phosphate
