Change the Air Filter on a 2018 Ford Escape SE
Template:FormatReplacing the air filter in your 2018 Ford Escape SE is a critical task that must be done periodically to keep your vehicle running in optimum shape. By following these steps below, you will be able to complete the job without a hitch.
Steps
- First start by parking vehicle and pulling the hood release lever located on the drivers side, under the instrument panel on the vertical kick panel. Of course, the vehicle must be off.
- Next raise the hood and locate the air box housing near the front of the vehicle, to the right hand side. It's very important to note that if the vehicle has been running prior to this, engine components may be HOT.
- Gather the tools needed:
- Drill
- 8mm deep socket
- Socket extension (2"+ in length)
- Loosen the 4 hex-head screws, preparing the upper (A) part of the air-box housing to be removed from the lower (B) part exposing the air-filter.
- Firmly grip the right side of the air filter, and lift in a hinge manner. Twisting the air filter slightly while doing this may help with removal.
- Now that the old air filter removed, it's a great time to clean the housing. Debris, leaves, and even bugs make their way in and reduce air flow.
- New filter in hand, and in the same hinge manner, insert the mating end of the air filter into the mating part of the lower (B) housing unit. Twisting action may be needed.
- It's important to pay attention to the orientation of the air filter, and the 2 housing unit components. A lip located on the right side of the upper (A) and lower (B), must be in good alignment with the air filter.
- Now that the new filter is in place and in good alignment with the lower (B) housing unit, replace upper (A), and prepare to fasten. Note the (B) unit, (A) unit, and air filter are good alignment.
- Fasten the housing unit back together using the 8mm screws. Only 5-10 ft/lbs of torque is needed.
- Be sure no tools or discarded trash is left in the engine bay, and firmly close the hood of the vehicle.
- Start the vehicle and look for any alarms/warning signals. An improperly installed air filter will cause the vehicle to "throw a code" indicating a reinstallation is needed.
