Install a Paint Protection Film Kit for Your Car

All patterns are precisely cut to fit the entire area of your vehicle needing protection.Follow these simple steps for an accurate installation of your paint protection kit.


  1. Clean area of vehicle to be protected. Use the water with rubbing alcohol to remove any dirt and wax. It is always best to wash the vehicle first.
  2. Make sure your hands are clean. Spray area of vehicle with soapy water and remove backing paper from pattern applying soapy water to both sides of film. If film has a top protector sheet, remove this first.
  3. Lay the film down and line up the edges. There will be key fitment areas such as emblems, lights, corners, etc.
  4. Squeegee the water out from the center of the film outward. Work {{safesubst:#invoke:convert|convert}} at a time, stretching when necessary. For areas or contours that need fast adhesion, lift up the film and rinse using alcohol water.
  5. Use the paper towels to dry the edges of the film and prevent the water from seeping back under the film. Dry film completely and apply a coat of sealer.

Things You'll Need

  • Flexible squeegee
  • Two sprayers with solutions of soapy water + little rubbing alcohol
  • Paper towels
  • Plexus polish or other non-petroleum polish or sealer

Related Articles