Make a Tech Deck Tabletop Ramp

This article will teach you how to make a tech deck tabletop ramp, which you can use for doing tricks and grinds.

Steps

Make 2 forward and backward ramps about {{safesubst:#invoke:convert|convert}} tall and {{safesubst:#invoke:convert|convert}} wide. The ramps should be made of wood and they should look like a scaled down version of a razor "punk ramp".
Heat up a hot glue gun. You will need it for later.
Make a tabletop converter. It is basically a rectangular piece of wood.
Hot glue the tabletop converter in the middle of the forward and backward ramp.
Finished.

you could also use cardboard to make this ramp.
Try taking out the table top converter and scaling the 2 "punk ramps" to make a spine ramp.
Try making a bigger ramp.
Tape the ramp to the surface that you are tech decking on. this will keep it from sliding(be careful. it might hurt your board).