Install a Wood Dash Kit

Installation of aftermarket dash kits including but not limited to wood, carbon fiber and aluminum dash trim.

Steps

Check Fit and Alignment
Clean surface with alcohol wipes.
Carefully check fit of each dash piece to ensure proper alignment. Do not remove red backing at this time.
Use Alcohol Pad to wipe surface clean. The surface must be free of all debris and oils(armor all,etc) for the kit to adhere properly.
Carefully apply adhesion promoter. (included) Only apply to areas to be covered with kit.
For larger pieces carefully position dash piece in plate. Carefully pull back top half and remove red liner work from middle back to top then carefully remove red liner and continue with middle to bottom. (For small pieces you can remove entire red liner)
To complete installation firmly press dash into position and hold momentarily.
After kit is installed use a clean soft cloth and wipe(polish) to finish.