Spin and Recover a Cessna 150

This is a series of instructions on how to enter and recover from a spin in a Cessna 150, light aircraft. A spin is a flight maneuver that is potentially very dangerous to pilots. A spin involves a rotation about the aircraft's vertical axis - nose to tail - together with a rapid loss of altitude. Recognition of spin symptoms, avoidance of fully developed spins and recovery are the only aims of practicing a spin, as it has no practical application in normal flight training.

Steps

Spin Entry

1. Complete a HASEL check before entering the spin.
   • H – Height: make sure you are at least {{safesubst:#invoke:convert|convert}}+ AGL (Above Ground Level). A higher altitude is safer.
   • A – Area: check that you are over a relatively empty area of ground.
   • S – Security: verify your that your seat belt and doors are secured.
   • E – Engine: make sure your fuel valve is set to ON, your mixture knob is set to rich (all the way in), the carb heat is pulled HOT, oil and temperature gauges are within the green limits, and that your magnetos are set to both with the master switch (red switch on left) is set to on. This can be accomplished using a “7-Up Check” which will be described in the notes.
   • L – Lookout: perform a gentle turn (no more than 15 degrees of bank) to the left and then the right, forming an S. This is to verify for traffic below you and around you.
2. Begin stall entry procedures. Reduce the throttle and gradually pull back on the control column. This will bring the nose of the aircraft up. Maintain this until you stall the aircraft.
3. As the stall begins, apply full rudder by pressing down on the pedal in whichever direction you wish to spin.
4. Allow the auto-rotation (spin) to develop by holding the full rudder input and the back-pressure on the control column. The aircraft should now be in a spin.

Spin Recovery

1. Pull the throttle completely back, setting the engine to idle.
2. Apply and hold full rudder opposite to the direction of rotation.
3. Once full rudder is engaged, apply forward pressure on the control column to break the stall with a nose down attitude.
4. Hold both rudder and nose down attitude until the rotation stops.
5. Once the rotation is stopped, neutralize the rudder, level the wings, and climb back to your assigned altitude.

Tips

• For the “E” (Engine) in the HASEL check it is easiest to do with a 7-up check [Image 3]. This is basically forming a 7 starting near the floor with the fuel selector, then working across to form the top of the 7 by checking the mixture, carb heat, gauges, master switch and magnetos.
• When stalling the aircraft, make sure to recognize the signs of stall: buffeting, stall horn and a loss of aileron (bank or roll) control. This is when it is best to apply the full rudder to initiate the spin.

Warnings

• A proper walk around, to examine the aircraft for any defects or weaknesses is also very important for the safety of any flight. It is especially important prior to flights where the aircraft will be submitted to unusual stresses, as in the case of a spin.
• It is also best to have an experienced pilot or instructor with you before attempting this maneuver.
• It is very important to be at a safe height before attempting to execute a spin, as recovery will always take some altitude to achieve.
• Transport Canada states that a secondary spin may result “from mishandling the controls following recovery from the initial spin. An abrupt or premature pull-up from the dive recovery could cause a secondary stall”

Things You'll Need

• Aside from the aircraft, no materials are necessary to perform a spin.

Sources and Citations

• Cessna Aircraft Company. 150 Commuter: Pilot's Operating Handbook, Cessna Aircraft Company, 1987
• “Aircraft Stall Diagram”. Date Unknown. [Online]. Available: http://history.nasa.gov/SP-440/p42b.jpg. [Accessed: October 17, 2009].

See also

• Prepare for and Exit a Cessna 172 in the Event of a Crash Landing
• Fly a Cessna 182
• Perform a Forward Slip in a Cessna 152 to Descend Rapidly
• Start the Cessna 337 Engines
• Deal With an Engine Fire on a Cessna 150
• Enter and Recover from Slow Flight on a Cessna 150
• Enter and Recover from a Power off Stall in a Cessna 150
• Perform a Forced Approach in a Cessna 150
• Perform a Walk Around on a Cessna 150
• Do a Crosswind Landing in a Cessna 150

Read more ...

What links here

• Do a Circuit in a Cessna 150
• Deal With an Engine Fire on a Cessna 150
• Extinguish an Engine Fire in a Cessna 150 During Startup
• Enter a Spin in a Cessna 150