Use an ATV Ramp Xtender

This article explains how to use an ATV Ramp Xtender with your ATV.

Steps

Unload, unfold and set up Ramp.
Secure loop end of strap around a rung of the ramp.
Place the hook end underneath truck bumper.
Tighten safety straps to remove slack.
Loading your ramp.
Align ramps with ATV wheels.
- Safety Precautions: Always wear a helmet.
Never load/unload alone.
Loosen and unhook the strap.
Take the ramp without extension pins and form a 90 degree angle.
Face the rubber bumpers down.
Place ramp with pins facing down and line up with holes in the lower ramp.
Loop the keyhole strap through either the first or second traction rung.
Pass strap through the push button and hook over the top tailgate post.
Repeat on opposite side.
Loop the strap around the bottom rail and around the traction run closest to the ramp hinge.
Pass the strap through the push button buckle and tighten.
Connect to latch by the trunk to secure.

Take your time setting up the ramps on to your truck and always double check the slack from the straps when tightening the strap, the tighter the better.